Before starting intelligent setup, you must make sure your equipment is working properly. Look at your sender and receiving card. The red and green diodes should be bright on the sender card. The red diode should light up on the receiving card and the green diode will flashing if your receiver card working normally. This means that the signal from the videocard normally enters to your control system. If the cards do not work normally, change the connecting wires to others. Replace dvi hdmi or ethernet between devices of your control system. If after replacing the wires your cards continue to work incorrectly, try updating the firmware of the cards or replace them.

Related News
LED Control System
For your Novastar or Linsn and DBstar control system work correctly, you need the Rcg rcfg rcfgx rsps settings file. This file contains data about the LED module of which your screen is composed. The file contains the parameters of the modules such as frequencies, the distribution of LEDs in groups, the types of IC chips used, the resolution of the module and cabinet and some other data. Typically, your screen seller will provide you with the correct rcfg rcg file, but sometimes this does not happen or your screen is very old and the file is lost. In this case, you can try to select and download rcg rcfg config file for your modules from the database on this site. There is also an intelligent setting through which you can create a new file. If you cannot find the rcg file for your led wall, write to site admin. The process of creating a configuration file can be difficult for a beginner and has many nuances.
2. Get IC names on the module board.
However, as far as we know, many buyers can not find their LED display suppliers any more after some years. PS outdoorXV1. PS-A1 2PA. PS-Division by 3-left P4- SBO. PHS-E5 E PSxoutdoor SMD. PSxcombined driver board PSxseparate driver board PxHUBdouble color.
However, once you have an LED display, the struggle of setting it up does vanish anywhere too. Because an LED display requires a proper software setup to display graphics that you desire on the screen. Therefore, to achieve the desired graphics on the display, you must understand the guide on how to set linsn LED studio software and RCG file on your display. This makes it a highly crucial configuration file in terms of the LED display module. For this, first, you need to install the Linsn LED studio. The further steps include:. After the software is opened, click on the options, and then the software setup option.